Thrust Vectored Rocket Thrust Vectored Rocket Styrofoam body cut to shape. Gluing The body and cutting chamfers on the corners. Wrapping Styrofoam in fiberglass. Mixing epoxy for wetting out the fiberglass. I chose to try dying the clear epoxy green but later I realized it didn't look good. "Max 1618" epoxy used for all my fiberglass and carbon fiber layups. Letting the fiberglass cure wrapped on its form. Getting ready to use the "lost wax" method to free the tube by dissolving the Styrofoam with acetone. A quick image after just 3 seconds, and a few ml of acetone. This took more than 2 minutes. It took more than 15 minutes to finish cleaning it out. Lithium Polymer battery used for powering the rocket. Four servos will be used. One for each fin and thrust vane.